Mold pre-treatment requirements:For different product requirements, mold pre-treatment should be sprayed with release agent 2-5 times. For products with high surface requirements, the release agent on the mold must be wiped clean with a clean cotton cloth to reduce fogging and leaving marks.

Common problem (1):Mold residue (mold release agent residue/resin residue)
Solution (1):Release agent residue: If too much release agent is sprayed, there may be residue, so it is necessary to wipe the mold with a clean cloth after spraying the release agent.
Resin residue: This is a normal phenomenon, and when resin residue is seen on the mold, it is necessary to clean the mold.

Common problem (2):The surface of the produced product is uneven
Solution (2):New molds generally require sealing treatment, which can be done with sealing agents or by applying several coats of release agent.

Common problem (3):The product produced has white spots
Solution (3):Too much release agent was applied and the mold was not brushed or wiped clean, resulting in accumulation.

prev：The usage method and main performance of golf club release agent

next：Types, properties, and applications of silicone release agents

Service Items